The alternative to this would be to just ignore the virtual NIC and set another LAN on port 3 of the PCI-E NIC and connect that port to the motherboard port, then bridge the motherboard port to your VMs like you normally would (all except pfSense). Then in proxmox, bridge that virtual NIC with its internal network. On the virtual NIC in proxmox, don’t give any IP to the port, assign one in pfSense instead. Then you get away with 3 ports free, 2 from the NIC, 1 from the motherboard. In pfSense, set that virtual NIC as OPT1 (probably name it proxmox) and set another subnet in there. Nah, simplest way to configure this would be to make 1 LAN on port 2 and connect that to the switch, then on the Proxmox side, create a virtual NIC in the pfSense VM. Ok, not sure if VLANs are even worth doing on such a device. If you switch is managed and supports port bonding, aka link aggregation (LAgg), then you’re gold. Make one port the WAN, then use the other 3 for separate VLANs, or even all of them in LACP or balance-alb if your switch doesn’t support LACP. If I try changing the login page to point to I get a CORS error in the dev tools window even though in the config.IMO, the easiest option would be to passthrough your PCI-E quad port NIC to your pfSense VM. Should the frontend be pointing to the todo-api instead?

In my reverse proxy I have two subdomains setup I tried it with the trailing / and I still get Request failed with status code 405 So the login page already has though not with the trailing / Hope this makes some sense as I barely understand what I am trying to ask No matter what I do the error is always the same in the UI it says Request failed with status code 405 Todo-api - Host Starts With: /api/v1įor the todo-api I have tried various ACL config Host Starts With: /api/v1 Then the frontends I have an ACL and Action for eachĪCL’s todo - Host matches:. In HAProxy I have set up 2 backends and 2 frondendsīackends forwards traffic to .x:8079

My firewall/reverse proxy knowledge is cobbled together when I need something then not used for long and long so my terminology might be complete garbage! So I am assuming that I have the dockers setup correctly as I can create a user and login if I use the local ip address. I reverse proxy lots of services but this is the first one where I need to parse the url and send anything that has /api/v1 on it to a different place. I am struggling with the reverse proxy bit. I am running an UnRaid server behind a pfsense firewall which runs HAProxy as a reverse proxy.

Pfsense docker